The following is an overview of the user manual for the Z-Wave product Key Fob Gen5 (ZW088-A)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
It is a four buttons design. You can use each button to control your home’s Z-Wave devices and build a Z-Wave network for them.
Products that are Z-Wave certified can be used and communicate with other Z-Wave certified devices.
Security
As a Z-Wave Plus certified product, Key Fob Gen5 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Key Fob Gen5 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Short press the “Include” button on the Key Fob, it will go into inclusion state and its blue LED will blink slowly to wait including other slave Z-Wave devices.
Short press the “Exclude” button on the Key Fob, it will go into exclusion state and its red LED will blink slowly to wait excluding other slave Z-Wave devices from its network.
Short press the “Learn” button on the back of the Key Fob.
Press and hold the ""Learn"" for 3 seconds will trigger sending the Wake up notification command.
Factory reset Key Fob Gen5
Use this procedure only in the event that the primary controller is missing or otherwise inoperable.
Press and hold the “Mode” button and “Learn” button for 20 seconds and then release.
It can also activate 8 Z-Wave Scenes.
Please note that this is a user manual Key Fob Gen5 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Key Fob Gen5 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.