The following is an overview of the user manual for the Z-Wave product LED Bulb 6:Multi-Colour (ZWA002-A)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
✓ RGBW: dimmable from 5% to 100%, tunable from 1800K to 6500K, and 16 million colors
✓ Possible to be included in groups, scenes, or schedules
✓ Suitable for indoor lighting: Corridors, Bedroom, Living Room, etc.
Security
As a Z-Wave Plus certified product, LED Bulb 6:Multi-Colour supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes LED Bulb 6:Multi-Colour as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset LED Bulb 6:Multi-Colour
Reset the Device.
1. Assuming led bulb was added to controller and was power on.
2. RGBW bulb re-power 6 times (between 0.5-2 seconds each time).
Note: ON -> OFF -> ON -> OFF -> ON -> OFF -> ON -> OFF -> ON -> OFF -> ON -> OFF -> ON
3. If the 6th power on, the led bulb change to Yellow color(into pairing process ), which means that the reset factory settings are successf.
Using this action in case of the primary controller is missing or inoperable.
Add for inclusion
1. Ensure the led bulb has been excluded outside the network.
2. Triggered by OFF ->ON (between 0.5-2 seconds each time)
3. LED solid yellow Color (0xFFFF00) during the pairing(Timeout is 10 seconds).
Failure:
Blinks between 100% White and Red 0x0000FF color for 3 seconds (at a rate of 200ms per flash), Once 3 seconds have passed, the LED should return to a Warm White LED at 100%
Success:
Blinks between 100% White and Green 0x00FF00 color for 3 seconds (at a rate of 200ms per flash). Once 3 seconds have passed, the LED should return to a Warm White LED at 100%.
Remove for exclusion
1. Assuming led bulb was added to controller.
2. Triggered by OFF -> ON -> OFF -> ON -> OFF -> ON (between 0.5-2 seconds each time).
3. LED Solid Purple/Violet Color (0xEE82EE) during the unpairing process. (Timeout is 10 seconds).
Failure:
Blinks between 100% White and Red 0x0000FF color for 3 seconds (at a rate of 200ms per flash), Once 3 seconds have passed, the LED should return to the last color ( memory status(color cc set)) of LED Bulb.
Success:
Blinks between 100% White and Blue 0x0000FF color for 3 seconds (at a rate of 200ms per flash). Once 3 seconds have passed, the LED should return to a Warm White LED at 100%.
Please note that this is a user manual LED Bulb 6:Multi-Colour from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have LED Bulb 6:Multi-Colour and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.