LED Bulb 6- Multi-White (ZWA001-A) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product LED Bulb 6: Multi-White (ZWA001-A)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
LED Bulb 6: Multi-White
SKU Code
ZWA001-A
Description
Standard form factor and appearance of the light bulb with 800 lm output
Tunable white: dimmable from 5% to 100%, tunable from 2700K to 6500K.
Possible to be included in groups, scenes, or schedules
Suitable for indoor lighting: Corridors, Bedroom, Living Room, etc.
Version #
HW: 1 FW: 1.10 was the version certified
Certification #
ZC10-18036059
Certified
2018-03-16T16:21:38.304162
Z-Wave Version
6.71.01

Security

As a Z-Wave Plus certified product, LED Bulb 6: Multi-White supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Aeotec describes LED Bulb 6: Multi-White as having the following features:

  • Color
  • Firmware updatable via a compatible Z-Wave gateway
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Factory reset LED Bulb 6: Multi-White

Reset the device :
a) Please use this procedure only when the network primary controller is missing or otherwise inoperable.
b) Led bulb re-power 6 times (between 0.5-2 seconds each time); If the 6th power on, the led bulb flashes twice, which means that the resetting is successful.

Remove for exclusion:
a) Set the Z-Wave network main controller into removing mode.
b) Led bulb re-power 3 times (between 0.5-2 seconds each time).
c) Wait a moment, the led bulb should be removed from the controller.Then the led bulb will flash once, dim to 5% first, and then increased to 100% after 5 seconds.

Add for inclusion:
a) Set the Z-Wave network main controller into adding mode.
b) Power cycle once for led bulb(OFF->ON).The led bulb will flash twice and send node info frame.
c) Wait a moment, the led bulb should be added to the controller.Then the led bulb will flash once when it has been included into the network.

Please note that this is a user manual LED Bulb 6: Multi-White from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have LED Bulb 6: Multi-White and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.