The following is an overview of the user manual for the Z-Wave product LED Strip (ZW121-D)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
The LED Strip can also communicate securely via AES 128 wireless Z-Wave commands and supports Over-The-Air (OTA) firmware upgrades.
Security
As a Z-Wave Plus certified product, LED Strip supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes LED Strip as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Switch Type
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset LED Strip
Press and hold the Action Button on the LED Strip Controller for 20 seconds and then release it.
Use this procedure only in the event that your primary network controller is missing or inoperable.
Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.
Turn the primary controller of Z-Wave network into inclusion mode, press the Action Button on the LED Strip Controller.
Turn the primary controller of Z-Wave network into exclusion mode, press the Action Button on the LED Strip Controller.
Please note that this is a user manual LED Strip from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have LED Strip and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.