Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

MultiSensor 7 (ZWA024-A) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product MultiSensor 7 (ZWA024-A)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
MultiSensor 7
SKU Code
ZWA024-A
Description
Aeotec MultiSensor 7 is a Z-Wave™ smart sensor. The corner of your room just got 6 times smarter. It’s a motion sensor and it’s also so much more. Installing this 1 piece of Z-Wave technology is the same as installing 6 pieces of Z-Wave technology. Your home control network will immediately understand motion, temperature, humidity,light, Ultraviolet and Vibration readings wherever MultiSensor 6 is installed. Those intelligent readings will equate to intelligent automation. And intelligent automation will give you the perfect smart home.
Version #
HW: 1 FW: 1.01 was the version certified
Certification #
ZC12-21080291
Certified
2021-08-10T12:04:12.020578
Z-Wave Version
7.12.2

Security

As a Z-Wave Plus certified product, MultiSensor 7 supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated

Features

Aeotec describes MultiSensor 7 as having the following features:

  • Battery powered using CR123A batteries
  • Color
  • Battery Quantity
  • Firmware updatable via a compatible Z-Wave gateway
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

SmartStart location

SmartStart QR code's location as follows: User guide section in the User manual.

1. Turn your primary controller into inclusion mode.
2. Press once the Action Button on the product.

1. Turn your primary controller into exclusion mode.
2. Press once the Action Button on the product.

Press and hold the Action button on product for 2-5s.

Factory reset MultiSensor 7

Press and hold the Action Button on product for 15-20s.

The Sensor supports RSS and AOS role type:

1. When battery powered, the device will act as RSS.
2. When USB adpater powered, the device will act as AOS.

Note: The device must be re-included in the network if changing its role type.

If the product is in sleep state for a long time and your gateway shows it is in offline state, you can rediscover it via pressing and holding the Action Button for 3 seconds, then the Sensor will send a wake_up notification report to your gateway and let your gateway that it is still online.

Please note that this is a user manual MultiSensor 7 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have MultiSensor 7 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.