The following is an overview of the user manual for the Z-Wave product MultiSensor Gen5 (ZW074-A)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
Security
As a Z-Wave Plus certified product, MultiSensor Gen5 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes MultiSensor Gen5 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Z-Wave button that you can find in the back of the product.
Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Z-Wave button that you can find in back of the product.
Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.
N/A
Factory reset MultiSensor Gen5
Press and hold the Z-Wave button that you can find in back of the product for 20 seconds and then release. This procedure should only be used when the primary controller is inoperable.
Press and hold the Z-Wave button for 3 seconds will trigger sending the Wake up notification command. If press the Z-Wave button 3 times, the MultiSensor will wake up for 10 minutes.
Please note that this is a user manual MultiSensor Gen5 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have MultiSensor Gen5 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.