The following is an overview of the user manual for the Z-Wave product Nano Dimmer (ZW111-A)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
It can connect to 2 external manual switches to control the load ON/OFF independently. Its surface has a pin socket, which can be used for connecting to the touch panel, so you can also use the touch panel to control the Nano Dimmer.
The Nano Dimmer is also a security Z-Wave plus device and supports Over The Air (OTA) feature for the products firmware upgrade.
Security
As a Z-Wave Plus certified product, Nano Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Nano Dimmer as having the following features:
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Supported Meter Type
- Switch Type
- Z-Wave Scene Type
- Neutral Wire Required
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action button that you can find on the product's housing.
Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action button that you can find on the product's housing.
Factory reset Nano Dimmer
Press and hold the Action button that you can find on the product's housing for 20 seconds and then release. This procedure should only be used when the primary controller is inoperable.
Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.
Please note that this is a user manual Nano Dimmer from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Nano Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.