The following is an overview of the user manual for the Z-Wave product NanoMote Quad (ZWA003-A)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
Security
As a Z-Wave Plus certified product, NanoMote Quad supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Aeotec describes NanoMote Quad as having the following features:
- Battery Quantity
- Battery powered using LIR2450 batteries
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset NanoMote Quad
Pressing and holding a button for 20 seconds. Release the button after 20 seconds, LED will keep in yellow for 3 seconds. Scene Controller will be reset to factory defaults if you short press the button within this 3 seconds.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Pressing and holding a button for 3 seconds. Led will turn to green,
which means Scene Controller has been woken up.
Included device:
1. Insert the LIR2450 battery.
2. Set the Z-Wave network main controller into learning mode (see Z-Wave network controller operating manual).
3. Pressing and holding a button for 3 seconds.
4. If the inclusion is successful, the LED will blink in green less than for 5 seconds and then keep on for 15 seconds.
To remove the NanoMote Quad from the Z-Wave network:
(1) Insert the LIR2450 battery.
(2) Set the Z-Wave network main controller into remove mode
(see Z-Wave controller operating manual).
(3) Triple click the a button, if the exclusion is successful, LED
will blink long.
Please note that this is a user manual NanoMote Quad from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have NanoMote Quad and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.