The following is an overview of the user manual for the Z-Wave product Radiator Thermostat (4251295701387)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
The display of the thermostat has a background light and has a big LCD screen. Besides you can also lock the local buttons as a child protection.
The multicolor LED of the central button allows a intuitive usability because the User is invited to follow the instruction based on the blinking LED of the middle butto.
The TRV can either be used as heating thermostat or as a actuator depending on the configuration of the device. The measured temperature or the position of the actuator of the thermostat are transfered to the Z-Wave gateway.
Security
As a Z-Wave Plus certified product, Radiator Thermostat supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Aeotec describes Radiator Thermostat as having the following features:
- Battery Quantity
- Color
- Thermostat HVAC Systems Supported
- Thermostat Modes
- Battery powered using AA batteries
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Set your Z-Wave primary Controller into exclusion mode. Press and hold the Boost button for 5 seconds. The LCD screen of the sensor will show "LEA". Leave the Radiator thermostat as it is until the multicolor LED will light up green and the LCD screen will show "0". If the exclusion failed, the screen will show the failed code "18".
Factory reset Radiator Thermostat
Remove batteries.
Press and hold boost button.
While still holding boost button insert batteries.
The LCD shows RES. Release boost button.
To perform the factory reset press boost button.
Start the Inclusion mode of your primary Z-Wave Controller. Press the Boost-Button of the Thermoast. The Radiator thermostat will show the assigned NodeID.
This device is a FLIRS device. There is no procedure to wake up the device, because it will receive commands immediately and is always listening.
Please note that this is a user manual Radiator Thermostat from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Radiator Thermostat and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.