The following is an overview of the user manual for the Z-Wave product Range Extender 6 (ZW117-A01)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
The Range Extender can also communicate securely via AES 128 wireless Z-Wave commands and supports Over-The-Air (OTA) firmware upgrades.
Security
As a Z-Wave Plus certified product, Range Extender 6 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Range Extender 6 as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Turn the primary controller of Z-Wave network into inclusion mode, press the Z-Wave Button on Range Extender 6.
Turn the primary controller of Z-Wave network into exclusion mode, press the Z-Wave Button on Range Extender 6.
Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.
Factory reset Range Extender 6
Press and hold the Z-Wave Button for 20 seconds and then release it.
Use this procedure only in the event that your primary network controller is missing or inoperable.
Please note that this is a user manual Range Extender 6 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Range Extender 6 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.