The following is an overview of the user manual for the Z-Wave product Siren Gen5 (ZW080-B21)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
Those security and safety features are matched by smart features. Siren’s speaker system can access 5 different audio alerts, allowing your smart home to pick the alert best suited to the emergency. The speaker system’s volume can also be adjusted so that Siren is perfect for every space in every home.
It also act as a repeater that forward Z-Wave command messages to destination nodes if the originating controller is out of range from the destination node.
By taking advantage of the Z-Wave mesh network, commands can be routed to their destination via intermediary “listening” Z-Wave products. Products that are Z-Wave certified can be used and communicate with other Z-Wave certified devices.
Also a tool that can be programmed, scheduled, controlled and communicated with from anywhere in the world.
Security
As a Z-Wave Plus certified product, Siren Gen5 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Siren Gen5 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action button that you can find on the product's housing.
Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action button that you can find on the product's housing.
N/A
Factory reset Siren Gen5
Press and hold the Action button that you can find on the product's housing for 20 seconds and then release. This procedure should only be used when the primary controller is inoperable.
N/A
Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.
Please note that this is a user manual Siren Gen5 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Siren Gen5 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.