The following is an overview of the user manual for the Z-Wave product Smart Switch 6 (ZW096-B09)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
Its surface has a Smart RGB LED, which can be used for indicating the output load status or strength of the wireless signal. You can configure its indication colour according to your favour.
The Smart Switch 6 is also a security Z-wave device and supports Over The Air (OTA) feature for the products firmware upgrade.
Security
As a Z-Wave Plus certified product, Smart Switch 6 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Smart Switch 6 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action button that you can find on the product's housing.
Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action button that you can find on the product's housing.
Factory reset Smart Switch 6
Press and hold the Action button that you can find on the product's housing for 20 seconds and then release. This procedure should only be used when the primary controller is missing or inoperable.
N/A
N/A
1, Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.
2, Its surface has a Smart RGB LED, which can be used for indicating the output load status.
Please note that this is a user manual Smart Switch 6 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Switch 6 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.