Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

WallMote Quad (ZW130-B) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product WallMote Quad (ZW130-B)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
WallMote Quad
SKU Code
ZW130-B
Description
Aeotec WallMote Quad is an intelligent Z-Wave remote controller that mounted on a wall. It has 4 touch buttons that you can easily control the Z-Wave devices in your home network via touching, long pressing or sliding the button areas.
Its surface has a RGB LED to indicate the button actions also accompanied by touch beep and vibration.
The WallMote Quad is also a security Z-Wave device and supports Over The Air (OTA) feature for the products firmware upgrade.
Version #
HW: 130 FW: 2.00 was the version certified
Certification #
ZC10-17035520
Certified
2016-12-29T21:41:02.416131
Z-Wave Version
6.61.00

Security

As a Z-Wave Plus certified product, WallMote Quad supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Aeotec describes WallMote Quad as having the following features:

    • Firmware updatable via a compatible Z-Wave gateway
    • Z-Wave Scene Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action button that you can find on the product's housing.

    Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action button that you can find on the product's housing.

    Factory reset WallMote Quad

    Press and hold the Action button that you can find on the product's housing for 20 seconds and then release. This procedure should only be used when the primary controller is missing or inoperable.

    Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.

    Please note that this is a user manual WallMote Quad from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have WallMote Quad and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.