Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Water Sensor 6 (ZW122-B) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Water Sensor 6 (ZW122-B)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Water Sensor 6
SKU Code
ZW122-B
Description
Aeotec by Aeon Labs Water Sensor 6 brings intelligence to a new level, one that is suited to both safety and convenience. It contains 4 sensing points, which would be more accurately to detect the presence and absence of water or detect whether there is water leak in some places of your home. The Water Sensor 6 has an inbuilt buzzer that can play alarm sounds to let you know when the water is detected.

The Water Sensor 6 is also a security Z-Wave device that supports Over The Air (OTA) for firmware updates.
Version #
HW: 122 FW: 1.01 was the version certified
Certification #
ZC10-17055616
Certified
2017-05-23T05:44:31.659451
Z-Wave Version
6.51.09

Security

As a Z-Wave Plus certified product, Water Sensor 6 supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Aeotec describes Water Sensor 6 as having the following features:

    • Battery powered using CR123A batteries
    • Firmware updatable via a compatible Z-Wave gateway
    • IP (Ingress Protection) Rated
    • Sensors
    • Battery Quantity
    • Supported Notification Types
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset Water Sensor 6

    Press and hold the Action Button that you can find on the product for 20 seconds and then release. This procedure should only be used when the primary controller is inoperable.

    Pressing the Action Button once will trigger sending the Wake up notification command. If press and hold the Z-Wave button for 3 seconds, the Water Sensor will wake up for 10 minutes.

    Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.

    Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action Button that you can find on the product.

    Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action Button that you can find on the product.

    Please note that this is a user manual Water Sensor 6 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Water Sensor 6 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.