The following is an overview of the user manual for the Z-Wave product Water Sensor 7 Pro (ZWA019-A)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
Thanks to the latest Z-Wave 700 series technology, the Water Sensor 7 is distinguished with and increased range, S2 Security, OTA FW update and SmartStart.
Security
As a Z-Wave Plus certified product, Water Sensor 7 Pro supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Aeotec describes Water Sensor 7 Pro as having the following features:
- Battery Quantity
- Battery powered using 1/2 AA batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Water Sensor 7 Pro
Reset to factory default
This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be used when the primary controller is inoperable.
Once Cover is removed and the tamper switch is tripped, push the tamper for 5 seconds until the RED LED blinks once. Then release tamper and push it again for 5 seconds while the RED LED is blinking until the GREEN LED blinks once.
- The product is able to perform a range test to the gateway by setting parameter 4 as described in the manual
SmartStart location
SmartStart QR code's location as follows: The DSK for the S2 inclusion can be found inside the sensors packaging.
Inclusion
1. Open the housing.
2. Remove the battery protection.
3. Press the tamper on the side of the appliance three times quickly.
Exclusion
1. Open the housing.
2. Press the tamper on the side of the appliance three times quickly.
The Node Information Frame (NIF) is the business card of a Z-Wave device. It contains information about the device type and the technical capabilities. The inclusion and exclusion of the device is confirmed by sending out a Node Information Frame. Beside this it may be needed for certain network operations to send out a Node Information Frame. To issue a NIF execute the following action: Press the tamper once
Please note that this is a user manual Water Sensor 7 Pro from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Water Sensor 7 Pro and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.