The following is an overview of the user manual for the Z-Wave product Z-pi7 Eu (ZWA025)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
The Z-Pi 7 is attached to the GPIOs of the host, such as a PC,as your primary Z-Wave controller. Then it can be used with your any automation software as long as it supports the Z-Wave Serial Bridge API.
Security
As a Z-Wave Plus certified product, Z-pi7 Eu supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Z-pi7 Eu as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Communications Protocol
- Controller Supports Multiple Z-Wave Interfaces
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Z-pi7 Eu
To reset your Z-PI7 please refer to the automation software of your host PC.
Note: If you reset your Z-PI7, it will disconnect from all your Z-Wave nodes.
Please note that this is a user manual Z-pi7 Eu from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-pi7 Eu and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.