The following is an overview of the user manual for the Z-Wave product Z-Stick 7 EU (ZWA010-C)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
It can easily be plugged into the USB interface of your host PC. Then it can be used with your any automation software as long as it supports the Z-Wave Serial Bridge API.
Security
As a Z-Wave Plus certified product, Z-Stick 7 EU supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Z-Stick 7 EU as having the following features:
- Communications Connections
- Controller Supports Multiple Z-Wave Interfaces
- Color
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Z-Stick 7 EU
To reset your Z-Stick 7 please refer to the automation software of your host PC.
Note: If you reset your Z-Stick 7, it will disconnect from all your Z-Wave nodes within its network.
Please note that this is a user manual Z-Stick 7 EU from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Stick 7 EU and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.