The following is an overview of the user manual for the Z-Wave product Z-Stick Gen5+ (ZW090-B)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Stick Gen5+ supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Z-Stick Gen5+ as having the following features:
- Color
- Communications Connections
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Z-Stick Gen5+
3.4 How to factory reset
You can through one of the following ways to perform this function:
1.To be done through the host software which takes control of the Z-Stick USB adapter while the Z-Stick is in SerialAPIMode (If you don’t know how to do this, please consult the instruction manual of the host software to perform a
network reset).
2.Unplug the Z-Stick from the USB connector,Then press and hold down the Reset Button for 20 seconds.
Please note that this is a user manual Z-Stick Gen5+ from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Stick Gen5+ and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.