The following is an overview of the user manual for the Z-Wave product Z-Stick Gen5 (ZW090-D)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
Products that are Z-Wave certified can be used and communicate with other Z-Wave certified devices.
Security
As a Z-Wave Plus certified product, Z-Stick Gen5 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Z-Stick Gen5 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Z-Stick Gen5
Use this procedure only in the event that the primary controller is missing or otherwise inoperable.
Press and hold the Action Button on Z-Stick for 20 seconds and then release.
Support Over The Air for firmware Upgrade.
Plug the Z-Stick into USB port of your host Controller and then click the “Exclusion” button on your PC/host Controller application.
Plug the Z-Stick into USB port of your host Controller and then click the “Learn” button on your PC/host Controller application.
Plug the Z-Stick into USB port of your host Controller and then click the “Inclusion” button on your PC/host Controller application.
Please note that this is a user manual Z-Stick Gen5 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Stick Gen5 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.