The following is an overview of the user manual for the Z-Wave product Alarm Base Station (Ring Base Station)from Ring. To view other Z-Wave products and manuals from Ring follow that link.
Overview
The Ring Protect system together with Ring's video doorbells, cameras, and accessories, creates a stronger-than-ever Ring of Security that protects your home both inside and out. Whether you’re on vacation halfway around the world, or just too busy with the kids upstairs, Ring lets you watch over your home from anywhere. Because with Ring, you’re always home.
Ring Features:
- High-definition video
- Wide-angle camera lens
- Two-way talk
- Advanced motion detection
- Infrared night vision
- Video recording
- Lifetime purchase protection
- 24/7 Professional monitoring
- Monitor your doors and windows
Security
As a Z-Wave Plus certified product, Alarm Base Station supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
Ring describes Alarm Base Station as having the following features:
- Color
- Communications Protocol
- Sensors
- Supported Notification Types
- Communications Connections
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Classic Inclusion Steps:
1. Start inclusion mode on the primary controller
2. From the application’s UI, navigate to controller’s device setting screen -> select Advance options -> Select Z-wave from “Protocol Adapters” and Select “Learn Mode” – DSK will be displayed (refer to the picture below)
3. Select “Begin Learn Mode” in the UI
4. When the inclusion process in complete, the LED on the base station will be solid blue
Note: Joining another Z-Wave network via learn mode is available only when the base station is not already paired to any other devices
*Learn Mode*
Learn Mode allows you to add a controller to an existing Z-Wave network. When a controller enters Learn Mode, it looks for another controller to communicate with.
To enter Learn Mode:
1. Open the menu, then tap Devices.
2. Tap Protect.
3. Tap the Ring Protect Base Station.
4. Tap Settings.
5. Tap Advanced Options.
6. Tap Z-Wave.
7. Tap Learn Mode.
8. Tap Enter Learn Mode.
Factory reset Alarm Base Station
Factory Default Instructions
1. Using a paper clip press and hold the reset button
2. Wait for the network and power LEDs on the back to start to blink amber color
3. Release the reset button
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Exclusion Instructions:
1. Start exclusion mode on the primary controller
2. From the application’s UI, navigate to controller’s device setting screen -> select Advance options -> Select Z-wave from “Protocol Adapters” and Select “Learn Mode” – DSK will be displayed
3. Select “Begin Learn Mode” in the UI
4. When the exclusion process in complete, the LED on the base station will be solid blue
Please note that this is a user manual Alarm Base Station from Ring is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Alarm Base Station and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.