The following is an overview of the user manual for the Z-Wave product Glass Break Sensor EU (Glass Break Sensor EU)from Ring. To view other Z-Wave products and manuals from Ring follow that link.
Overview
Security
As a Z-Wave Plus certified product, Glass Break Sensor EU supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
Features
Ring describes Glass Break Sensor EU as having the following features:
- Battery Quantity
- Battery powered using AA batteries
- Color
- Outdoor Use
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Classic Inclusion Steps:
1. Initiate add flow for Security Devices in the Ring mobile application – Follow the guided add flow instructions provided in the Ring mobile application.
2. Select add manually and enter the 5-digit DSK pin found on the package of the Ring Alarm Glass Break Sensor or the 5-digit DSK pin found under the QR code on the device.
3. After powering on the device, press and hold the setup button on the front for 3 seconds. Release the button and the device will enter Classic inclusion mode.
Classic Inclusion Steps:
1. Initiate add flow for Security Devices in the Ring mobile application – Follow the guided add flow instructions provided in the Ring mobile application.
2. Select add manually and enter the 5-digit DSK pin found on the package of the Ring Alarm Glass Break Sensor or the 5-digit DSK pin found under the QR code on the device.
3. After powering on the device, press and hold the setup button on the front for 3 seconds. Release the button and the device will enter Classic inclusion mode.
Exclusion Instructions:
1. Initiate remove “Ring Alarm Glass Break Sensor” flow in the Ring Alarm mobile application – Select the settings icon from device details page and choose “Remove Device” to remove the device. This will place the controller into Remove or “Z-Wave Exclusion” mode.
2. With the controller in Remove (Z-Wave Exclusion) mode, use a paper clip or similar object and tap the pinhole button. The device’s red LED turns on solid to indicate the device was removed from the network.
Comm Test / Manual Wake Up
A comm test can be triggered by press the button on the front of the device. This will cause the device to send a Comm test Notification. A solid Green LED indicates a successful comm test.
Factory reset Glass Break Sensor EU
Factory Default Instructions
1. 1. To restore Ring Alarm Glass Break Sensor to factory default settings, locate the pinhole reset button on the device. This is found inside the battery compartment on the back of the device after removing the back bracket.
2. Using a paperclip or similar object, insert it into the pinhole, press and hold the button down for 10 seconds.
3. The device will rapidly blink green continuously for 10 seconds. After about 10 seconds, when the green blinking stops, release the button. The red LED will turn on solid to indicate the device was removed from the network.
Please note that this is a user manual Glass Break Sensor EU from Ring is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Glass Break Sensor EU and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.