The following is an overview of the user manual for the Z-Wave product Keypad (4AK1S70EN0)from Ring. To view other Z-Wave products and manuals from Ring follow that link.
Overview
The keypad will include an interactive button interface, an informational display, a speaker, various LED lights, wall mount option, battery power, AC power option and additional features to extend control of the Ring Protect system beyond the user’s mobile device and web applications. The keypad is intended to be used as a “dumb” terminal and will be non-programmable for end users.
Security
As a Z-Wave Plus certified product, Keypad supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Ring describes Keypad as having the following features:
- Color
- Supported Notification Types
- Battery powered using Rechargable batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart Inclusion Steps:
1. Initiate add keypad flow in the Ring Alarm mobile application – Follow the guided add flow instructions provided in the application
2. Scan the QR code found on the package of the keypad or the QR code found on the back of the keypad
3. Plug in the keypad to line power
4. When the inclusion process in complete, the LED on the keypad will be solid blue, then go out.
5. Test the Keypad. Any button presses would beep
Classic Inclusion Steps:
1. Initiate add keypad flow in the Ring Alarm mobile application – Follow the guided add flow instructions provided in the application
2. Select add manually and enter the 5 digit DSK pin found on the package of the keypad or the QR code found on the back of the keypad
3. Plug in the keypad to line power
4. Press and hold “1” key for three seconds
5. When the inclusion process in complete, the LED on the keypad will be solid blue, then go out.
6. Test the Keypad. Any button presses would beep
Exclusion Instructions:
1. Initiate remove keypad flow in the Ring Alarm mobile application – Select the settings icon from device details page and choose “Remove Device”
2. Press and hold “1” key for three seconds
3. When the exclusion process in complete, the LED on the keypad will be solid blue, then go out.
4. Test the Keypad. Any button presses would not beep
Factory reset Keypad
Factory Default Instructions
1. Press and hold “5” key and using a pointed end of a paperclip, gently press and release reset button via the reset pin hole found at the back of the keypad
2. Red network LED at the top left-hand corner will start to blink rapidly
3. Wait for the red LED to stop blinking then release the “5” key
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Keypad from Ring is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Keypad and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.