The following is an overview of the user manual for the Z-Wave product Motion Detector (EU) (4SPAE9-0EU0)from Ring. To view other Z-Wave products and manuals from Ring follow that link.
Overview
* Requires the Ring Alarm Security Kit
* Advanced motion sensitivity to prevent false alarms from pets
* Mounts to room corners or flat walls
Security
As a Z-Wave Plus certified product, Motion Detector (EU) supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Ring describes Motion Detector (EU) as having the following features:
- Battery Quantity
- Color
- Battery powered using CR123 batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Follow the instructions provided in Ring Alarm Mobile Application, select add manually and enter the 5 digit DSK pin found on the package of the sensor or found on the back of the sensor.
Classic Inclusion Steps:
1. Initiate add sensor flow in the Ring Alarm mobile application – Follow the guided add flow instructions provided in the application
2. Follow the instructions provided in Ring Alarm Mobile Application, select add manually and enter the 5 digit DSK pin found on the package of the sensor or found on the back of the sensor
3. Pull the battery tab on the sensor
4. When the inclusion process in complete, the LED on the sensor will be solid blue, then go out.
5. Test the sensor. Place the sensor in an unoccupied room. Leave the room for at least four minutes. Return to the room and pass in front of the sensor – LED will flash if motion is detected.
Smart Start Inclusion Steps:
1. Initiate add sensor flow in the Ring Alarm mobile application – Follow the guided add flow instructions provided in the application
2. Follow the instructions provided in Ring Alarm Mobile Application, Scan the QR code found on the package of the sensor or the QR code found on the back of the sensor
3. Pull the battery tab on the sensor
4. When the inclusion process in complete, the LED on the sensor will be solid blue, then go out.
5. Test the sensor. Place the sensor in an unoccupied room. Leave the room for at least four minutes. Return to the room and pass in front of the sensor – LED will flash if motion is detected.
Exclusion Instructions:
1. Initiate remove sensor flow in the Ring Alarm mobile application – Select the settings icon from device details page and choose “Remove Device”
2. Open motion sensor’s cover
3. Remove and replace battery quickly
Wake-Up Notification
The sensor will wake up every so often and when the case is closed to send a Wake-Up Notification to allow the life line master node controller that the sensor is now available for any queued messages that the controller may have for the sensor. The time between Wake-Up Notifications can be configured with the Wake-Up Notification command class to be between 1 and 24 hours.
Factory reset Motion Detector (EU)
Factory Default Instructions
1. Using a pointed end of a paperclip, press and hold the reset button via the reset pin hole found at the back of the sensor
2. Blue LED will start to blink rapidly
3. Wait for the blue LED to stop blinking Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Motion Detector (EU) from Ring is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Motion Detector (EU) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.