The following is an overview of the user manual for the Z-Wave product Motion Sensor (RING-PIR-SS)from Ring. To view other Z-Wave products and manuals from Ring follow that link.
Overview
Security
As a Z-Wave Plus certified product, Motion Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Ring describes Motion Sensor as having the following features:
- Battery powered using CR123A batteries
- Supported Notification Types
- Firmware updatable via a compatible Z-Wave gateway
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Exclusion Instructions:
1. Initiate remove sensor flow in the Ring Alarm mobile application – Select the settings icon from device details page and choose “Remove Device”
2. Open motion sensor’s cover
3. Remove and replace battery quickly
Removing the top cover will put the sensor in tamper mode and will keep the sensor awake
Ring Motion Sensor can be added via SmartStart or via classic inclusion mode –
SmartStart Inclusion Steps:
1. Initiate add sensor flow in the Ring Alarm mobile application – Follow the guided add flow instructions provided in the application
2. Scan the QR code found on the package of the sensor or the QR code found on the back of the sensor
3. Pull the battery tab on the sensor
4. When the inclusion process in complete, the LED on the sensor will be solid blue, then go out.
5. Test the sensor. Place the sensor in an unoccupied room. Leave the room for at least four minutes. Return to the room and
pass in front of the sensor – LED will flash if motion is detected.
Classic Inclusion Steps:
1. Initiate add sensor flow in the Ring Alarm mobile application – Follow the guided add flow instructions provided in the application
2. Select add manually and enter the 5 digit DSK pin found on the package of the sensor or the QR code found on the back of the sensor
3. Pull the battery tab on the sensor
4. When the inclusion process in complete, the LED on the sensor will be solid blue, then go out.
5. Test the sensor. Place the sensor in an unoccupied room. Leave the room for at least four minutes. Return to the room and
pass in front of the sensor – LED will flash if motion is detected.
Factory reset Motion Sensor
Factory Default Instructions
1. Using a pointed end of a paperclip, press and hold the reset button via the reset pin hole found at the back of the sensor
2. Blue LED will start to blink rapidly
3. Wait for the blue LED to stop blinking
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Motion Sensor from Ring is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Motion Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.