The following is an overview of the user manual for the Z-Wave product Range Extender (Range Extender)from Ring. To view other Z-Wave products and manuals from Ring follow that link.
Overview
Security
As a Z-Wave Plus certified product, Range Extender supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Ring describes Range Extender as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Battery powered using Rechargeable Battery batteries
- Color
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Ring Range Extender can be added via SmartStart or via classic inclusion mode –
SmartStart Inclusion Steps:
1. Initiate add range extender flow in the Ring Alarm mobile application – Follow the guided add flow instructions provided in the application
2. Scan the QR code found on the package of the range extender or the QR code found on the back of the range extender
3. Plug in the range extender to line power
4. When the inclusion process in complete, the LED on the range extender will be solid blue, then go out.
Classic Inclusion Steps:
1. Initiate add range extender flow in the Ring Alarm mobile application – Follow the guided add flow instructions provided in the application
2. Select add manually and enter the 5 digit DSK pin found on the package of the range extender or the QR code found on the back of the range extender
3. Plug in the range extender to line power
4. Press and hold the push button for three seconds and release
5. When the inclusion process in complete, the LED on the range extender will be solid blue, then go out.
Factory reset Range Extender
Factory Default Instructions
1. Press and hold the push button
2. Blue LED will start to blink rapidly
3. Wait for the blue LED to stop blinking then release the push button
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Exclusion Instructions:
1. Initiate remove range extender flow in the Ring Alarm mobile application – Select the settings icon from device details page and choose “Remove Device”
2. Press and hold the push button for three seconds
3. When the exclusion process in complete, the LED on the range extender will be solid blue, then go out.
Please note that this is a user manual Range Extender from Ring is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Range Extender and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.