The following is an overview of the user manual for the Z-Wave product Retrofit Alarm Kit (4AW1SZ-0EN0)from Ring. To view other Z-Wave products and manuals from Ring follow that link.
Overview
Security
As a Z-Wave Plus certified product, Retrofit Alarm Kit supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Ring describes Retrofit Alarm Kit as having the following features:
- Battery powered using CR123 batteries
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Exclusion Instructions:
1. Initiate remove keypad flow in the Ring Alarm mobile application – Select the settings icon from device details page and choose “Remove Device”
2. Press and hold “1” key for three seconds
3. When the exclusion process is complete, the LED on the keypad will be solid blue, then go out
4. Test the Keypad. Any button presses would not beep
SmartStart location
SmartStart QR code's location as follows: When prompted for the QR Code or DSK PIN, you can find them inside of the top cover of the device, on the box, or on a card inside the box. Keep the device nearby. You’ll be prompted to pull the battery tab to confirm the connection.
Classic Inclusion Steps:
1. Initiate add flow in the Ring Alarm mobile application – Follow the guided add flow instructions provided in the Ring Alarm Mobile application
2. Select add manually and enter the 5 digit DSK pin found on the package of the Ring Alarm Retrofit Kit or the 5 digit DSK pin found on the inside of the top cover of the device.
4. When the inclusion process in complete, the LED on the keypad will be solid green, then go out.
Smart Start Inclusion Steps:
1. Initiate add flow in the Ring Alarm mobile application – Follow the guided add flow instructions provided in the Ring Alarm Mobile application
2. Scan the QR code found on the package of the Ring Alarm Retrofit Kit or the QR code found on the inside of the top cover of the device.
4. When the inclusion process in complete, the LED on the keypad will be solid green, then go out.
The sensor will wake up every so often to send a Wake-Up Notification to allow the life line master node controller that the sensor is now available for any queued messages that the controller may have for the sensor. The time between Wake-Up Notifications can be configured with the Wake-Up Notification command class to be between 1 and 24 hours with interval steps of 1 minute.
Factory reset Retrofit Alarm Kit
Ring Keypad – Reset
Factory Default Instructions
1. Press and hold “5” key and using a pointed end of a paperclip, gently press and release reset button via the reset pinhole found at the back of the keypad
2. Red network LED at the top left-hand corner will start to blink rapidly
3. Wait for the red LED to stop blinking then release the “5” key
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Retrofit Alarm Kit from Ring is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Retrofit Alarm Kit and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.