The following is an overview of the user manual for the Z-Wave product Z-Wave Dimmer (SQR22101**Z)from Square D. To view other Z-Wave products and manuals from Square D follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Square D describes Z-Wave Dimmer as having the following features:
- Switch Load Capacity Volt-Ampere
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Quick click x3, within 1.5s/ interval <0.5s
SmartStart location
SmartStart QR code's location as follows: The DSK can be found on the product packaging.
Quick click x3, within 1.5s/ interval <0.5s
Factory reset Z-Wave Dimmer
Quick click x3 +press x 1 >10 seconds
Please note that this is a user manual Z-Wave Dimmer from Square D is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.