The following is an overview of the user manual for the Z-Wave product Z-Wave Plus Plug-in (SQR62102WHZ)from Square D. To view other Z-Wave products and manuals from Square D follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Plus Plug-in supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Square D describes Z-Wave Plus Plug-in as having the following features:
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Exclusion from a Z-Wave network (Figure 4): When the gateway is in removing mode (please refer to the instruction of the Z-Wave gateway for the operations on gateway itself). Press the program button 3 times within 1.5s (the interval between each press is less than 0.5s).
Factory reset Z-Wave Plus Plug-in
Long press the reset button for >20 seconds till the blue LED blink 5 times within one second.
SmartStart location
SmartStart QR code's location as follows: The DSK can be found on the product and its packaging.
A. SmartStart inclusion: The feature assumes the gateway has implemented SmartStart. Users could use the APP of the gateway or the gateway camera to scan the QR code (located on the device or on the enclosed label in the package) before powering on the device, and then when the device is powered on, it shall be automatically added to the gateway.
B. Manual inclusion (Figure 4): When the gateway is in adding mode (please refer to the instruction of the Z-Wave gateway for the operations on gateway itself). Press the program button 3 times within 1.5s (the interval between each press is less than 0.5s).
Please note that this is a user manual Z-Wave Plus Plug-in from Square D is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plus Plug-in and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.