Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Z-Wave Plus Switch (SQR14102**Z (** means color code)) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave Plus Switch (SQR14102**Z (** means color code))from Square D. To view other Z-Wave products and manuals from Square D follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Z-Wave Plus Switch
SKU Code
SQR14102**Z (** means color code)
Description
The Square D 15 Amp Z-Wave Switch Single Pole/3-WAY Energy Monitoring is the professionals choice for secure reliable lighting control. Sensitive enough to control the low wattage demands of a single LED yet as well as the demands of bright outdoor lighting. Perfect for monitoring energy usage in bedrooms where the switch controls the receptacles. It works with any Z-Wave hub and can be grouped with up to 5 other Z-Wave Plus devices.
Version #
HW: 1 FW: 1.17 was the version certified
Certification #
ZC12-21030193
Certified
2021-03-04T13:17:26.680664
Z-Wave Version
7.13.6

Security

As a Z-Wave Plus certified product, Z-Wave Plus Switch supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated

Features

Square D describes Z-Wave Plus Switch as having the following features:

  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Exclusion from a Z-Wave network (Figure 6):
When the gateway is in removing mode (please refer to the instruction of the Z-Wave gateway for the operations on gateway itself).

Factory reset Z-Wave Plus Switch

Long press the reset button for >20 seconds till the blue LED blink 5 times within one second.

SmartStart location

SmartStart QR code's location as follows: The DSK can be found on a lable inside the product packaging.

A. SmartStart inclusion:
The feature assumes the gateway has implemented SmartStart. Users could use the APP of the gateway or the gateway camera to scan the QR code on device or on device package before powering on the device, and then when the device is powered on, it shall be automatically added to the gateway.

B. Manual inclusion (Figure 6):
When the gateway is in adding mode (please refer to the instruction of the Z-Wave gateway for the operations on gateway itself).

Please note that this is a user manual Z-Wave Plus Switch from Square D is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plus Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.