Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Z-Wave Receptacle (SQR44101**Z) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave Receptacle (SQR44101**Z)from Square D. To view other Z-Wave products and manuals from Square D follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Z-Wave Receptacle
SKU Code
SQR44101**Z
Description
The Square D 15 Amp Z-Wave Plus Energy Monitoring Duplex Receptacle is the professionals choice for secure reliable lighting control. For use in areas where you want to control a device that is not connected to a switch. The receptacle mounts inside the electrical box like a standard device so it blends into the home. Perfect for monitoring energy usage of the device plugged into the controlled outlet. It works with any Z-Wave hub and can be grouped with up to 5 other Z-Wave Plus devices.
Version #
HW: 1 FW: 1.11 was the version certified
Certification #
ZC10-20076941
Certified
2020-07-08T15:17:37.56793
Z-Wave Version
6.82.01

Security

As a Z-Wave Plus certified product, Z-Wave Receptacle supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated

Features

Square D describes Z-Wave Receptacle as having the following features:

  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

A. SmartStart inclusion: The feature assumes the gateway has implemented SmartStart. Users could use the APP of the gateway or the gateway camera to scan the QR code on device or on device package before powering on the device, and then when the device is powered on, it shall be automatically added to the gateway.
B. Manual inclusion: When the gateway is in adding mode (please refer to the instruction of the Z-Wave gateway for the operations on gateway itself), press the program button 3 times within 1.5s (the interval between each press is less than 0.5s).

Exclusion from a Z-Wave network: When the gateway is in removing mode (please refer to the instruction of the Z-Wave gateway for the operations on gateway itself), press the program button 3 times within 1.5s (the interval between each press is less than 0.5s)

SmartStart location

SmartStart QR code's location as follows: The DSK can be found on the product packaging.

Factory reset Z-Wave Receptacle

3x quick click +1 x press> 10 seconds.

Please note that this is a user manual Z-Wave Receptacle from Square D is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Receptacle and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.