The following is an overview of the user manual for the Z-Wave product Z-Wave Switch Single Pole (SQR14101**Z)from Square D. To view other Z-Wave products and manuals from Square D follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Switch Single Pole supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Square D describes Z-Wave Switch Single Pole as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
When the gateway is in removing mode (please refer to the instruction of the Z-Wave gateway for the operations on gateway itself):
quick click x3, (within 1.5s/ interval<0.5s), on either top or bottom paddle.
Factory reset Z-Wave Switch Single Pole
3x quick click +1 x press> 10 seconds, on either top or bottom paddle.
SmartStart location
SmartStart QR code's location as follows: The DSK can be found on the product packaging.
*Smart Start Inclusion
The feature assumes the gateway has implemented Smart Start. Users could use the APP of the gateway or the gateway camera to scan the QR code on device or on device package even before powering on the device, when the device is powered on, it shall be automatically added to the gateway.
*Manual Inclusion
When the gateway is in adding mode (please refer to the instruction of the Z-Wave gateway for the operations on gateway itself):
quick click x3, (within 1.5s/ interval<0.5s), on either top or bottom paddle.
Please note that this is a user manual Z-Wave Switch Single Pole from Square D is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Switch Single Pole and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.