Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-wall Dimmer (SR-ZV9101SAC-HP-US) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-wall Dimmer (SR-ZV9101SAC-HP-US)from Sunricher. To view other Z-Wave products and manuals from Sunricher follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-wall Dimmer
SKU Code
SR-ZV9101SAC-HP-US
Description
The in-wall dimmer is a Z-Wave device that is used to switch ON/OFF and adjust light intensity of the connected light and can be controlled by other Z-Wave devices. The Inwall Dimmer can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non- battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
Version #
HW: 1 FW: 1.00 was the version certified
Certification #
ZC10-18056101
Certified
2018-04-30T20:51:17.766768
Z-Wave Version
6.71.01

Security

As a Z-Wave Plus certified product, In-wall Dimmer supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Sunricher describes In-wall Dimmer as having the following features:

  • Firmware updatable via a compatible Z-Wave gateway
  • Supported Notification Types
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

1. Set primary controller/gateway into inclusion mode (Please refer to your primary controllers manual on how to turn your controller into inclusion).
2. Power on the in-wall dimmer and set it into inclusion mode. There are two methods to set the in-wall dimmer into inclusion mode:
1)Repower on the dimmer, it will be set into inclusion mode automatically, and waiting to be included.
2)Triple press the action button on the dimmer, it will set the plug into inclusion mode.
The connected light will stay solid on for 3 seconds to indicate successful inclusion.

There are two exclusion methods:
Method 1: Exclusion from the primary controller/gateway as follows:
1. Set the primary controller/gateway into exclusion mode (Please refer to your primary controllers manual on how to set your controller into exclusion).
2. Triple press the action button, the dimmer will be set to exclusion mode, and waiting to be excluded, then the dimmer will be included to the network.
Method 2: Factory reset the dimmer will force the it to be excluded from a network.
(please refer to the part “Factory Reset” of this manual)
Note: Factory reset is not recommended for exclusion, please use this procedure only if the primary controller/gateway is missing or otherwise inoperable.

Factory reset In-wall Dimmer

Press and hold down the action button for over 10 seconds, the dimmer will be reset to factory defaults.

Note: Factory reset is not recommended for exclusion, please use this procedure only if the primary controller/gateway is missing or otherwise inoperable.

Please note that this is a user manual In-wall Dimmer from Sunricher is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-wall Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.