The following is an overview of the user manual for the Z-Wave product In-Wall Smart Switch (SR-ZV9100A-A)from Sunricher. To view other Z-Wave products and manuals from Sunricher follow that link.
Overview
The switch can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
Security
As a Z-Wave Plus certified product, In-Wall Smart Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Sunricher describes In-Wall Smart Switch as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset In-Wall Smart Switch
Press and hold down the action button for over 10 seconds, the dimmer will be reset to factory defaults.
1. Set primary controller/gateway into inclusion mode (Please refer to your primary controller’s manual on how to turn your controller into inclusion).
2. Power on the in-wall switch and set it into inclusion mode. There are two methods to set the in-wall switch into inclusion mode:
1)Repower on the switch, it will be set into inclusion mode automatically, and waiting to be included.
2)Triple press the action button on the switch, it will set the switch into inclusion mode.
There are two exclusion methods:
Method 1: Exclusion from the primary controller/gateway as follows:
1. Set the primary controller/gateway into exclusion mode (Please refer to your primary controllers manual on how to set your controller into exclusion).
2. Triple press the action button, the switch will be set to exclusion mode, and waiting to be excluded, then the switch will be excluded from the network.
Method 2: Factory reset the switch will force it to be excluded from a network. (please refer to the part “Factory Reset” of this manual)
Note: Factory reset is not recommended for exclusion, please use this procedure only if the primary controller/gateway is missing or otherwise inoperable.
Please note that this is a user manual In-Wall Smart Switch from Sunricher is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.