The following is an overview of the user manual for the Z-Wave product Thermostat-Heating (SR-ZV9092A-EU)from Sunricher. To view other Z-Wave products and manuals from Sunricher follow that link.
Overview
● OLED display and touch buttons
● also as remote control other thermostats for heating
● Internal sensor for room temperature , external Internal sensor for floor temperature
● Max Load 3680W @ 230V (resistive load),16A
● Alarm: over current, room temperature over heat
● Electric power measurement
● Internal overheating protection
Security
As a Z-Wave Plus certified product, Thermostat-Heating supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Sunricher describes Thermostat-Heating as having the following features:
- Thermostat Modes
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Switch Load Capacity Watts
- Thermostat HVAC Systems Supported
- Thermostat Power Source
- Electric Load Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: page 4 ：Z-Wave Set Introduction
lf the user's gateway also supports smartstart, add the device by scanning the QR code,Smartstart allows
users to quickly add devices to the gateway by scanning the device's QR code.
After scanning to add the device, reset power of the device or waiting for a while, the device will be added to the
gateway automatically. Please find the QR code on the casing of the device.
Adding to a Z-Wave Network (Inclusion)
Method 1: Select “Add”, then short press button , the device will send out inclusion request, “Status” will
show “Inclusion...”. If there is no response from a gateway within 30 seconds, or inclusion failed, “Status” will
show “Fail”. If included successfully, “Status” will show “Inclusion OK” and device ID.
Method 2: Operate the gateway into inclusion mode, make sure the device is already removed from previous
network, reset power of the device, the device will be included to the gateway automatically
Removing from a Z-Wave Network (Exclusion)
Select “Remove”, then short press button , the device will send out exclusion request, “Status” will show
“Exclusion...”. If there is no response from a gateway within 30 seconds, or exclusion failed, “Status” will show
“Fail”. If excluded successfully, “Status” will show “Exclusion OK” and device ID will be showed as 0.
Factory reset Thermostat-Heating
Factory Reset (Reset)
Select “Reset”, then short press button F , the device will start reset, “Status” will show “Reset...”. If there is no response from a gateway within 6 seconds, or exclusion failed, “Status” will show “Fail”. If reset
successfully, “Status” will show “Reset OK”
Please note that this is a user manual Thermostat-Heating from Sunricher is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Thermostat-Heating and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.