The following is an overview of the user manual for the Z-Wave product Z-Wave Smart Plug (SR-ZV9021A-EU)from Sunricher. To view other Z-Wave products and manuals from Sunricher follow that link.
Overview
can be controlled by other Z-Wave devices. The device supports metering function (voltage, current, energy
consumption and power), it also supports thermostat’s Heat Mode, Energy Heat Mode, OFF Mode. The device
cannot act as Z-Wave network controller (primary or secondary) and will always need a Z-Wave network
controller to be included into a Z-Wave network
The encryption modes that the smart plug supports are S0, S2 Unauthenticated. When the smart plug is being
included into a Z-Wave network, you can use your primary controller/gateway to enable one encryption mode or
disable encryption. (The primary controller/gateway shall support encryption mode configuration).
Security
As a Z-Wave Plus certified product, Z-Wave Smart Plug supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Sunricher describes Z-Wave Smart Plug as having the following features:
- Thermostat Modes
- Thermostat HVAC Systems Supported
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Triple press the action button on the smart plug, it will set the plug into inclusion mode.The LED indicator will flash a white LED fast then stay solid white for 3 seconds to indicate successful inclusion. If there is no Z-Wave network available, the LED indicator will flash white fast for 30 seconds and the plug will quit inclusion mode automatically.
Triple press the action button, the smart plug will be set to exclusion mode, the LED indicator will flash a
white LED fast and then flash white slowly for 3 times to indicate successful exclusion. If exclusion fails, the
LED indicator will flash fast for 30 seconds and the plug will quit exclusion mode automatically
Factory reset Z-Wave Smart Plug
Press and hold down action button for over 10 seconds, LED indicator stays solid white for 3s to indicate
successful factory reset, release action button, the smart plug will restart automatically.
SmartStart location
SmartStart QR code's location as follows: page 4 ：Z-Wave Set Introduction
lf the user's gateway also supports smartstart, add the device by scanning the QR code,Smartstart allows
users to quickly add devices to the gateway by scanning the device's QR code.
After scanning to add the device, reset power of the device or waiting for a while, the device will be added to the
gateway automatically. Please find the QR code on the casing of the device.
Please note that this is a user manual Z-Wave Smart Plug from Sunricher is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Smart Plug and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.