The following is an overview of the user manual for the Z-Wave product 4-in-1 Sensor 700 Series (ZSE40 700)from Zooz. To view other Z-Wave products and manuals from Zooz follow that link.
Overview
- 4 different sensors in 1 smart device: motion, light, temperature, and humidity
- Customize your sensor with adjustable motion and reporting settings
- NEW 700 Series Z-Wave™ Chip
- SmartStart and S2 Security
- Built-in tamper protection
SPECIFICATIONS:
- Power: 1 CR123A battery (included)
- Wireless Range: Up to 300 feet line of sight
- Operating Temperature: 5° - 104°F
- Weight: 2.0 oz
- Dimensions: 2.25" x 2.25" x 1"
- Installation: Indoor Use Only
Security
As a Z-Wave Plus certified product, 4-in-1 Sensor 700 Series supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Zooz describes 4-in-1 Sensor 700 Series as having the following features:
- Battery Quantity
- Battery powered using CR123A batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Under the back cover of the sensor.
Initiate inclusion (pairing) in the app (or web interface).
Click the Z-Wave button with a paperclip twice. The LED indicator will start flashing.
Initiate exclusion in the app (or web interface).
Click the Z-Wave button with a paperclip twice. The LED indicator will start flashing.
The sensor’s wake-up interval is set to 12
hours by default to save battery life. You
can change the wake-up interval using
your controller’s advanced settings if
available.
During wake-up, the sensor receives
communication from the hub (setting
updates or network information). Long
wake-up interval will not affect how
oen the sensor reports motion and
other values to your gateway controller.
MANUAL WAKE-UP
Press and release the Z-Wave button
once to wake the device up. The LED
indicator will flash once (blue or orange).
You may need to wake the sensor up
manually IF:
1. It doesn’t fully configure during set-up
(values are not displayed or errors
pop up in your hub’s interface).
2. You change advanced settings for the
sensor and want them to update.
Factory reset 4-in-1 Sensor 700 Series
If your primary controller is missing or
inoperable, you may need to reset the
device to factory settings. To complete
the reset process manually, remove the
back cover to trigger tamper switch.
Press and release the Z-Wave button
using a paperclip 10 TIMES quickly
(within 10 seconds).
Please note that this is a user manual 4-in-1 Sensor 700 Series from Zooz is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 4-in-1 Sensor 700 Series and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.