The following is an overview of the user manual for the Z-Wave product 4-in-1 Sensor 700 Series (ZSE40AU-700)from Zooz. To view other Z-Wave products and manuals from Zooz follow that link.
Overview
- 4 different sensors in 1 smart device: motion, light, temperature, and humidity
- Customize your sensor with adjustable motion and reporting settings
- NEW 700 Series Z-Wave™ Chip
- SmartStart and S2 Security
- Built-in tamper protection
SPECIFICATIONS:
- Power: 1 CR123A battery (included)
- Wireless Range: Up to 300 feet line of sight
- Operating Temperature: 5° - 104°F
- Weight: 2.0 oz
- Dimensions: 2.25" x 2.25" x 1"
- Installation: Indoor Use Only
Security
As a Z-Wave Plus certified product, 4-in-1 Sensor 700 Series supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Zooz describes 4-in-1 Sensor 700 Series as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Battery Quantity
- Battery powered using CR123A batteries
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Under Z-Wave Control
1. Insert the battery.
2. Place the sensor near the location where it will be mounted.
3. Initiate inclusion in the Z-Wave hub.
4. Click the Z-Wave button on the sensor with a paperclip once.
5. The LED indicator will blink red to signal communication and green once the PIN is entered, then turn off to confirm inclusion.
1. Initiate EXCLUSION and click the Z-Wave button on the sensor once.
2. Make sure the battery cover is closed tightly when adding the sensor.
3. Click the Z-Wave button once every 15 seconds for 2 minutes after the sensor joins the network to keep it
awake so it can fully configure.
4. Click the Z-Wave button on the sensor 6-7 times quickly when adding it.
Press and release the Z-Wave button once to wake the device up. The LED indicator will flash once (blue or orange).
Factory reset 4-in-1 Sensor 700 Series
If your primary controller is missing or
inoperable, you may need to reset the
device to factory settings. To complete
the reset process manually, remove the
back cover to trigger tamper switch.
Press and release the Z-Wave button
using a paperclip 10 TIMES quickly
(within 10 seconds).
Please note that this is a user manual 4-in-1 Sensor 700 Series from Zooz is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 4-in-1 Sensor 700 Series and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.