4-in-1 Sensor 700 Series (ZSE40EU-700) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product 4-in-1 Sensor 700 Series (ZSE40EU-700)from Zooz. To view other Z-Wave products and manuals from Zooz follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Zooz 4-in-1 Sensor 700 Series
SKU Code
- 4 different sensors in 1 smart device: motion, light, temperature, and humidity
- Customize your sensor with adjustable motion and reporting settings
- NEW 700 Series Z-Wave™ Chip
- SmartStart and S2 Security
- Built-in tamper protection

- Power: 1 CR123A battery (included)
- Wireless Range: Up to 300 feet line of sight
- Operating Temperature: 5° - 104°F
- Weight: 2.0 oz
- Dimensions: 2.25" x 2.25" x 1"
- Installation: Indoor Use Only
Version #
HW: 2 FW: 32.32 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, 4-in-1 Sensor 700 Series supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated


Zooz describes 4-in-1 Sensor 700 Series as having the following features:

  • Battery powered using CR123A batteries
  • Color
  • Firmware updatable via a compatible Z-Wave gateway
  • Battery Quantity
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

SmartStart location

SmartStart QR code's location as follows: Scan the QR code or enter the PIN located under the back cover if your hub supports SmartStart.

Initiate inclusion (pairing) in the app (or web interface).
Click the Z-Wave button once.
The LED indicator will blink red to signal communication and green once the PIN is entered, then turn off to confirm inclusion.

1. Bring the sensor within direct range of your Z-Wave gateway (hub).
2. Put the Z-Wave hub into exclusion mode (not sure how to do that? ask@getzooz.com).
3. Click the Z-Wave button with a paperclip once (it will blink green).
4. Your hub will confirm exclusion and the device will disappear from your controller's device list.

Press and release the Z-Wave button once to wake the device up. The LED indicator will flash once (blue or orange).

Factory reset 4-in-1 Sensor 700 Series

If your primary controller is missing or inoperable, you may need to reset the device to factory settings. To complete
the reset process manually, remove the back cover to trigger tamper switch. Press and release the Z-Wave button using a paperclip 10 TIMES quickly (within 10 seconds).

Please note that this is a user manual 4-in-1 Sensor 700 Series from Zooz is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 4-in-1 Sensor 700 Series and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.