The following is an overview of the user manual for the Z-Wave product 4-in-1 Sensor (ZSE40)from Zooz. To view other Z-Wave products and manuals from Zooz follow that link.
Overview
This is a secure device using 128-bit signal encryption. It requires a security enabled gateway controller for full functionality.
The Zooz 4-in-1 sensor is packed with advanced features:
- 7 levels of motion sensitivity to choose from
- 3 modes for motion / temp led indicator notifications
- Built-in tamper protection
- Low battery alerts
- Z-Wave Plus with improved 500 series chip for faster and safer wireless communication
Z-Wave Frequency: 908.42 MHz (US)
Power: 2 AAA batteries
Wireless Range: Up to 100 feet line of sight
Operating Temperature: 5° - 104°F
Installation: Indoor Use Only
1 Year Warranty
Security
As a Z-Wave Plus certified product, 4-in-1 Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Zooz describes 4-in-1 Sensor as having the following features:
- Sensors
- Battery Quantity
- Battery powered using AAA batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To add the ZSE40 to the Z-Wave network (inclusion), place the Z-Wave primary controller into inclusion mode. Press the Program Switch of ZSE40 for sending the NIF. After sending NIF, Z-Wave will send the auto inclusion, otherwise, ZSE40 will go to sleep after 20 seconds.
To remove theZSE40 from the Z-Wave network (exclusion), place the Z-Wave primary controller into “exclusion” mode and follow its instruction to delete the ZSE40 to the controller. Press the Program Switch of ZSE40 once to be excluded.
Factory reset 4-in-1 Sensor
Remove cover to trigged tamper switch, LED flash once & send out Alarm Report. Press Program Switch 10 times within 10 seconds, ZSE40 will send the “Device Reset Locally Notification” command and reset to the factory default. (Remark: This is to be used only in the case of primary controller being inoperable or otherwise unavailable.)
Use “Wake Up” command to set up the awaking time (from 10 minutes to 1 week) and send the wake up notification to controller
Please note that this is a user manual 4-in-1 Sensor from Zooz is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 4-in-1 Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.