The following is an overview of the user manual for the Z-Wave product 700 Series Outdoor Double Plug (ZEN14)from Zooz. To view other Z-Wave products and manuals from Zooz follow that link.
Overview
- Z-Wave™ on/off control of 2 individual loads
- IP65 rated for outdoor use
- Easy set-up and angled plug for better outlet fit
- S2 security and Z-Wave™ Plus technology
- Supports OTA firmware updates
- ETL listed for compliance with North American safety standards
SPECS:
- Z-Wave™ Frequency: 908.42 MHz (US)
- Power: 120 VAC, 60 Hz
- Maximum Loads: 960W incandescent, 150W LED bulbs, 15A resistive, 1/3 HP fan motors combined between 2 outlets
- Z-Wave™ Range: Up to 300 feet line of sight
- Dimensions: 5" tall, 3.5" wide, 1.75" deep
- Cord Length: 6.5"
- Operating Temperature: 32-104° F (0-40° C)
- Installation: Indoor or outdoor use, IP65 rated
Security
As a Z-Wave Plus certified product, 700 Series Outdoor Double Plug supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Zooz describes 700 Series Outdoor Double Plug as having the following features:
- Color
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Initiate inclusion (pairing) in the app (or web interface).
While the hub is looking for new devices, click the ZWave™ button 3 times as quickly as possible. The LED indicator will start flashing blue to confirm inclusion. mode and turn green for 1 second once inclusion is completed.
1. Bring the plug within direct range of your Z-Wave™ gateway (hub).
2. Put the Z-Wave™ hub into exclusion mode (not sure how to do that? ask@getzooz.com).
3. Press and release the Z-Wave™ button 3 times quickly.
4. Your hub will confirm exclusion and the plug will disappear from your controller's device list.
Factory reset 700 Series Outdoor Double Plug
When your network’s primary controller is missing or otherwise inoperable, you may need to reset the device to factory settings manually. In order to complete the process, make sure the plug is powered, then click the Z-Wave™ button twice and hold it the third time for 10 seconds. The LED indicator will flash green 3 times to confirm a successful reset.
Please note that this is a user manual 700 Series Outdoor Double Plug from Zooz is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 700 Series Outdoor Double Plug and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.