The following is an overview of the user manual for the Z-Wave product Double Switch (ZEN30)from Zooz. To view other Z-Wave products and manuals from Zooz follow that link.
Overview
- Manual or Z-Wave control of 2 separate loads (dimmer + relay)
- Perfect replacement for a fan / light combo (neutral wire required)
- Scene control for multi-tap scenarios on select hubs
- Quick and easy pigtail wire installation (single pole only)
- 4-color LED indicator and air-gap switch for added safety
- Fully customizable dimming features including ramp rate, on
brightness level, and double tap to full brightness
- Remembers and restores on/off status aer power failure
- Built-in Z-Wave Plus signal repeater to extend network range
- S2 security protocol and 500 Z-Wave chip
SPECIFICATIONS:
- Model Number: ZEN30
- Z-Wave Signal Frequency: 908.42 MHz
- Power: 120 VAC, 60 Hz
- Dimmer Max Load: 75 W LED, 250 W incandescent; DON’T use with tube lights, DC powered fixtures, or chandeliers
- Relay Max Load: 15 A (1/2 HP)
- Operating Temperature: 32-104° F (0-40° C)
- Installation and Use: Indoor only
Security
As a Z-Wave Plus certified product, Double Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Zooz describes Double Switch as having the following features:
- Color
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Loads Controlled
- Neutral Wire Required
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Initiate inclusion (pairing) in the app (or web interface).
2. Finalize inclusion at the switch. Tap the upper paddle of the dimmer 3 times quickly. The LED indicators will blink to signal communication and remain on for 2 seconds to confirm inclusion.
Bring your Z-Wave gateway (hub) close to the switch if possible
2. Put the Z-Wave hub into exclusion mode
3. Tap the lower paddle on the dimmer 3 times quickly
4. Your hub will confirm exclusion and the device will disappear from your
controller's device list
Factory reset Double Switch
If your primary controller is missing or inoperable, you may need to reset
the device to factory settings. To complete the reset process manually,
press and hold the lower paddle on the dimmer for at least 15 seconds
until the LED indicators start flashing, release. Then immediately press
and hold the upper paddle on the dimmer for at least 15 seconds. The
LED indicators will flash again to confirm successful reset.
Please note that this is a user manual Double Switch from Zooz is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Double Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.