The following is an overview of the user manual for the Z-Wave product S2 On/Off Switch (ZW303)from Zooz. To view other Z-Wave products and manuals from Zooz follow that link.
Overview
Security
As a Z-Wave Plus certified product, S2 On/Off Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Zooz describes S2 On/Off Switch as having the following features:
- Switch Load Capacity Watts
- Switch Type
- Z-Wave Scene Type
- Color
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1:Refer to your primary controller instructions to process the inclusion setup procedure.
2:When prompted by your primary controller, click the Up or Down button three times in one second.
Refer to your primary controller instructions to process the exclusion setup procedure.
2:When prompted by your primary controller, click the Up or Down button three times in one second.
Factory reset S2 On/Off Switch
Press click Z-Wave button 2 times quickly,and hold for at least 10 seconds. to restore the device to the factory
(Node:Please use this procedure only when the network primary controller is missing or otherwise inoperable.)
Please note that this is a user manual S2 On/Off Switch from Zooz is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have S2 On/Off Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.