The following is an overview of the user manual for the Z-Wave product temperature humidity XS SENSOR (ZSE44)from Zooz. To view other Z-Wave products and manuals from Zooz follow that link.
Overview
Security
As a Z-Wave Plus certified product, temperature humidity XS SENSOR supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Zooz describes temperature humidity XS SENSOR as having the following features:
- Battery Quantity
- Battery powered using CR2450 batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Printed on the inside of the sensor’s battery cover.
1. Initiate inclusion on your Z-Wave hub.
2. While the hub is looking for new devices, click the Z-Wave™ button 3 times as quickly as possible.
3. The LED indicator will start flashing to confirm inclusion mode and turn off once inclusion is completed.
The sensor’s wake-up interval is set to 12 hours by default to save battery life. Use the Wake Up Command Class to adjust the interval. Click the Z-Wave™ button 4 times quickly to wake the sensor up manually. The LED indicator will flash once to confirm the device is awake. During wakeup, the sensor turns the Z-Wave™ radio on for one minute to receive communication from the hub. Long wake-up interval will not affect how often the sensor reports to your hub so we recommend leaving the default setting to conserve battery.
Factory reset temperature humidity XS SENSOR
When your network’s primary controller is missing or otherwise inoperable, you may need to reset the device to factory settings manually. In order to complete the process, make sure the sensor is powered, then click the Z-Wave™ button twice and hold it the third time for 10 seconds. The LED indicator will blink continuously. Immediately after, click the Z-Wave™ button twice more to finalize the reset.
The LED indicator will flash 3 times to confirm a successful reset.
NOTE: All previously recorded activity and custom settings will be erased from the device’s memory.
Please note that this is a user manual temperature humidity XS SENSOR from Zooz is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have temperature humidity XS SENSOR and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.