The following is an overview of the user manual for the Z-Wave product Titan Water Valve Actuator (ZAC36)from Zooz. To view other Z-Wave products and manuals from Zooz follow that link.
Overview
Automatic shut-off actuator for your main water valve
Connect it to your Z-Wave™ hub for full smart home control
Use it offline with the included leak sensor probe
Built-in temperature detection for instant freeze detection
Retrofit installation with no tools required
Use with 1/2” - 1 1/4” ball valves only (close prior to installation)
Indoor & outdoor installation with IP66 rating (avoid direct sunlight)
NEW 700 series Z-Wave™ chip for better range and faster control
S2 Security and SmartStart for easier inclusion
PRODUCT SPECS:
Model Number: ZAC36
Z-Wave Signal Frequency: 908.42 MHz
Power: 12 V DC (1 A) power supply (included)
Temperature Sensor Range: -40° to 257° F
Sound Indicator: up to 85 dB
Z-Wave Range: Up to 400 feet line of sight (up to 130 feet indoors)
Operating Temperature: 14-122° F (-10-50° C)
Installation and Use: Indoor & outdoor (IP66)
Standby Power Consumption: 0.12 W
Full Operation Power Consumption: 8.4 W
Security
As a Z-Wave Plus certified product, Titan Water Valve Actuator supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Zooz describes Titan Water Valve Actuator as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Scan the QR Code on the back of the product / enter the 5 digit PIN.
1. Initiate inclusion in the hub
2. Tap the Z-Wave button 3 times
1. Put the Z-Wave hub into exclusion mode
2. Tap the Z-Wave button 3 times
Factory reset Titan Water Valve Actuator
If your primary controller is missing or inoperable, you may need to reset the device to factory settings. Please make sure that your Z-Wave button is unlocked before you proceed. To reset the Titan hold the Z-Wave button until 10 beeps sound. Release the button, and immediately after, tap the Z-Wave button 5 times. The LED indicator will flash yellow, then it will turn green for 2 seconds and will sound a long beep to confirm a successful reset.
Outdoor Installation.
Please note that this is a user manual Titan Water Valve Actuator from Zooz is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Titan Water Valve Actuator and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.