The following is an overview of the user manual for the Z-Wave product Z-Wave Mutil-relay (ZW11)from Zooz. To view other Z-Wave products and manuals from Zooz follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Mutil-relay supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Zooz describes Z-Wave Mutil-relay as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
ADD the ZW11 from the existing Z-Wave home control network with your primary controller.
Refer to your primary controller instructions to process the inclusion setup procedure.
When prompted by your primary controller, click the Program button three times in one second.
Remove the ZW11 from the existing Z-Wave home control network with your primary controller.
Refer to your primary controller instructions to process the exclusion setup procedure.
When prompted by your primary controller, click the Program button three times in one second.
Factory reset Z-Wave Mutil-relay
press 4x, then LED lit for 4s, within this time press 4x again – LED blinks 3 times then off to FACTORY RESET
Please note that this is a user manual Z-Wave Mutil-relay from Zooz is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Mutil-relay and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.