The following is an overview of the user manual for the Z-Wave product Z-Wave Plus Smart Chime (ZSE33)from Zooz. To view other Z-Wave products and manuals from Zooz follow that link.
Overview
- Audio and visual notifications triggered by other Z-Wave devices or scheduled in your routine
- Choose from 10 different sounds for chime and siren modes
- Advanced configuration available
- Powerful long-lasting batteries
- Z-Wave Plus with improved 500 chip for faster and safer wireless communication
- Small size and quick installation
Specifications:
Model Number: ZSE33
Z-Wave Signal Frequency: 908.42 MHz
Power: 2 CR123 batteries (included)
Power Consumption: 2W
Operating Temperature: 32 – 104 F
Range: Up to 100 feet line of sight
Installation and Use: Indoor only
Dimensions: 2.7” x 1.2”
Weight: 3 oz
Security
As a Z-Wave Plus certified product, Z-Wave Plus Smart Chime supports Z-Wave S2 security. The following security modes are directly supported:
Features
Zooz describes Z-Wave Plus Smart Chime as having the following features:
- Battery Quantity
- Battery powered using CR123 batteries
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Press and release the Z-Wave button three times.
1. Make sure the Smart Chime is powered on and located within direct range of your Z-Wave gateway controller
2. Put your Z-Wave controller in exclusion mode
3. Press and release the Z-Wave button 3 TIMES quickly. The LED indicator will flash quickly
4. The Smart Chime should disappear from your controller's device list
If the first attempt is unsuccessful, please repeat the process following all steps carefully.
Factory reset Z-Wave Plus Smart Chime
When your network’s primary controller is missing or otherwise inoperable, you may need to reset the device to factory settings manually. To complete the process, make sure the Smart Chime is powered on, then PRESS AND HOLD the Z-Wave button for AT LEAST 10 SECONDS until the LED indicator flashes ONCE. Release the button. NOTE: All previously recorded activity and custom settings will be erased from the device’s memory.
Auto Inclusion:
1. Put your Z-Wave controller in inclusion mode
2. Carefully remove the cover from the device
3. Remove the plastic pull-tab from the battery slot – the Chime will automatically enter inclusion mode for 20 seconds
4. A new alarm siren / doorbell device will appear on your controller's device list
Manual Inclusion:
1. Bring the Smart Chime within direct range of your controller
2. Carefully remove the cover from the device
3. Remove the plastic pull-tab from the battery slot. The LED indicator will blink slowly
4. Put your Z-Wave controller in inclusion mode
5. Press and release the Z-Wave button on the Smart Chime 3 TIMES quickly. The LED indicator
will flash quickly
6. A new alarm siren / doorbell device will appear on your controller's device list (if it connects as an on/off switch, you may need to change the device type manually. Contact us for instructions).
Please note that this is a user manual Z-Wave Plus Smart Chime from Zooz is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plus Smart Chime and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.