The following is an overview of the user manual for the Z-Wave product Z-Wave Power Strip (ZEN20)from Zooz. To view other Z-Wave products and manuals from Zooz follow that link.
Overview
- Scene inclusion for custom automation scenarios when included to a Z-Wave gateway controller
- Z-Wave Plus with improved 500 chip for faster and safer wireless communication
- Signal repeater for a stronger, more reliable network
- 2 USB charging ports for your smart phone or tablet (no Z-Wave functionality)
- Built-in overload protection
Specifications:
Z-Wave Signal Frequency: 908.42 MHz
Power: 110V
Maximum Load: 15Amps TOTAL between 5 outlets
USB Charging Port Power: 5V 1A each
Cord Length: 3 ft
Range: Up to 100 feet line of sight
Installation and Use: Indoor only
Security
As a Z-Wave Plus certified product, Z-Wave Power Strip supports Z-Wave S2 security. The following security modes are directly supported:
Features
Zooz describes Z-Wave Power Strip as having the following features:
- Switch Load Capacity Watts
- Loads Controlled
- Color
- Electric Load Type
- Switch Load Capacity Current
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Plug the power strip into a grounded receptacle located within 3 feet from your Z-Wave gateway controller
2. Put your Z-Wave controller in exclusion mode
3. Press and release the power button on the strip
4. The device should disappear from your controller's device list
1. Plug the power strip into a grounded receptacle located within 3 feet from your Z-Wave gateway controller
2. Put your Z-Wave controller in inclusion mode
3. Press and release the power button on the strip
4. A new on / off device should appear on your controller's device list
Factory reset Z-Wave Power Strip
When your network’s primary controller is missing or otherwise inoperable, you may need to reset the device to factory settings manually. In order to complete the process, plug the power strip into a grounded receptacle, then PRESS AND HOLD the power button for AT LEAST 3 SECONDS. NOTE: All previously recorded activity and custom settings will be erased from the device’s memory.
Please note that this is a user manual Z-Wave Power Strip from Zooz is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Power Strip and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.