The following is an overview of the user manual for the Z-Wave product Z-Wave Relay Dimmer switch (ZW34)from Zooz. To view other Z-Wave products and manuals from Zooz follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Relay Dimmer switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Zooz describes Z-Wave Relay Dimmer switch as having the following features:
- Color
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
ADD the ZW34 from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, quickly press 3x UPPER PADDLE FOR DIMMER
Remove the ZW34 from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
---When prompted by your primary controller, quickly press 3x LOWER PADDLE FOR DIMMER
Factory reset Z-Wave Relay Dimmer switch
Press and hold for 15 seconds LOWER PADDLE OF DIMMER until all LED’s start blinking quickly, then release and within 5 press and hold the UPPER PADDLE OF DIMMER for 15 SECONDS until all LED’s blink again for 3 seconds to reset factory
(Node:Please use this procedure only when the network primary controller is missing or otherwise inoperable.)
Please note that this is a user manual Z-Wave Relay Dimmer switch from Zooz is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Relay Dimmer switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.